System fault warning
|
This warning light is used to indicate to the driver the status of any non-tell-tale warnings. This is a bi-coloured warning lamp illuminated in either red or yellow depending upon what warnings currently exist.
The lamp is illuminated red if a red warning exists.
The lamp is illuminated yellow if a yellow warning exists.
If both red and yellow warnings exist simultaneously, then the LED is flashed alternately red and then yellow at 2 second intervals.
When ignition is off, the warning light provides information about the status of the alarm system.
|
SYSTEM FAULT WARNING
|
This warning light is used to indicate to the driver the status of any non-tell-tale warnings. This is a bi-coloured warning lamp illuminated in either red or yellow depending upon what warnings currently exist.
The lamp is illuminated red if a red warning exists.
The lamp is illuminated yellow if a yellow warning exists.
If both red and yellow warnings exist simultaneously, then the LED is flashed alternately red and then yellow at 2 second intervals.
When ignition is off, the warning light provides information about the status of the alarm system.
|
Engine Emission Fault
|
This warning light is used to indicate an emission related fault is detected by the engine management system. The indicator illuminates as a system check when the ignition is switched on and should extinguish when the engine is started.
If an engine operation problem occurs while the vehicle is being driven, the indicator will illuminate (and the message Engine Fault will appear in the message centre, MG6 only).
Seek an MG Authorised Repairer urgently.
|
Engine check
|
This warning light is used to indicate an engine operation fault is detected by the engine management system. The indicator illuminates as a system check when the ignition is switched on and should extinguish after a few seconds.
If a non-emissions related fault occurs while the vehicle is being driven, the indicator will illuminate (and the message Check Engine will appear in the message centre MG6 only).
Seek an MG Authorised Repairer urgently.
|
EPB Fault warning
|
This yellow warning light indicates a fault with the EPB, or that the EPB is in a diagnostic state. Warning lamp illumination is accompanied by an audible alarm.
|
Glow plug warning
|
The glow plug warning is used to indicate to the driver that the diesel engine glow plugs are still heating and are below their cut-off temperature threshold, above which the engine may be cranked.
|
anti-lock brake system
|
The warning light illuminates as a lamp check when the ignition is switched on.
If the light is illuminates, a fault has occurred with the ABS system (ABS Fail appears, MG6 only) and you should seek qualified assistance at the earliest opportunity.
If an ABS fault occurs while driving, ABS operation will be suspended, but normal braking will still be available. Seek qualified assistance at the earliest opportunity.
|
tyre pressure monitoring
|
The light illuminates yellow when the ignition is in position Ⅱ. It extinguishes after a few seconds.
If the light remains on, or illuminates red when driving, a low tyre pressure is indicated. Low Tyre Pressure will appear in the message centre.
If the light illuminates yellow a fault with the system is indicated. Tyre Pressure System Fail will appear in the message centre. Adjust your tyre pressures or seek an MG Authorised Repairer.
|
Brake pad wear
|
This warning light is illuminated to alert the driver that the brake pads are worn and need to be serviced. The message Front Brake Pads Worn or Rear Brake Pads Worn will appear in the message centre.
|
Stability control system
|
The warning light indicates that the Stability Control System (SCS system) is working or faulty. The warning light illuminates as a lamp check when the ignition is switched on.
If the SCS system is working, the warning light is off.
If the SCS system has a fault, this warning light will stay on. Stop the car as soon as safety permits and contact an MG Authorised Repairer.
When the SCS system has an intervention event, the warning light will flash.
|
stability control system off
|
The warning light indicates that the Stability Control System (SCS system) is switched on or off. The warning light illuminates as a lamp check when the ignition is switched on.
If the function of the SCS system is off, the warning light will illuminate all the time.
|
passenger airbag off warning
|
The warning light illuminates as a lamp check when the ignition is switched on, If the passenger airbag has been disabled, the light will illuminate until the airbag is enabled, Once the passenger airbag has been enabled, the light will extinguish.
|
Slip control system / traction control
|
The icon is displayed for approximately 7 seconds when the ignition is switched on.
If there is a fault with the system, the warning light will remain illuminated when the car is being driven. The message centre will display Stability Control Fail or Traction Control Fail as appropriate.
Stop the car as soon as safety permits and contact an MG Authorised Repairer for inspection at your earliest convenience.
If the warning light flashes during driving, this indicates that the system is taking control to assist the driver.
|
Cruise control
|
The light illuminates green when the master switch is pressed but no cruise speed is active and yellow when cruise control is active.
For MG6. The message centre will display Cruise Set ### MPH (### represents the speed set) or Cruise Control: Standby as appropriate. If a fault is detected, the warning light will flash yellow and the message Cruise Control: Fault will be displayed.
For MG3. When cruise control is set, the target speed is shown in the LCD, The target speed remains displayed until the actual speed achieves this, at which point the LCD reverts to its previous display.
|
Traction control warning off
|
The warning light indicates that the traction control is switched on or off. The warning light illuminates as a lamp check when the ignition is switched on, If the TC function is manually switched off, the warning light will illuminate all the time.
|
passenger airbag on
|
The warning light is located on the remote display module and is used to indicate that the passenger airbag has been enabled.
If the passenger airbag has been enabled, the light will remain illuminated until the airbag is disabled, and the message Passenger Airbag On will appear in the message centre. Once the passenger airbag has been disabled, the light will extinguish and the message Passenger Airbag Off will appear in the message centre.
|
Rear fog light
|
Illuminates when the rear fog light are switched on
|
Hill Descent Control (HDC) Malfunction
|
If the HDC system detects a fault or fails, the warning lamp illuminates yellow.
|
Electric Power Steering System (EPS)/ Electronic Steering Column Lock (ESCL) Warning
|
When this lamp illuminates yellow, it indicates that the EPS has a general failure and the performance is reduced. Please stop the car as soon as safety permits, switch the vehicle power system to the OFF position. Then restore the vehicle to READY and drive the vehicle for a short while. If this lamp remains on, please contact an MG Authorised Repairer immediately
If this lamp illuminates yellow and flashes, it indicates that the electronic steering column lock has failed. Please stop the car as soon as safety permits, switch the vehicle power system to the OFF position and seek an MG Authorised Repairer immediately. If the lamp extinguishes after a very short period it may be indicating that the steering is locked due to abnormal forces placed on the steering gear, please move the steering wheel left to right to allow the lock to operate without the influence of external forces.
|
Charging Status Indicator
|
When the vehicle is connected to an external power supply for charging, this lamp will remain on during charging and extinguish after charging is completed.
|
High-voltage Battery Pack Low Battery Warning
|
This lamp will illuminate when the high voltage battery charge is low, if the voltage continues to drop, this lamp will flash. Where possible please charge the high voltage battery before this lamp enters the flashing stage
|
High-voltage Battery Pack Cutoff Warning
|
When the high-voltage battery pack is connected, this lamp will not illuminate. This lamp will only illuminate when the high voltage battery is disconnected or isolated.
|
Driving Power Limited
|
This lamp will illuminate if the vehicle power has been reduced
|
Lane Departure Warning System Indicator
|
This lamp will illuminate yellow when the Lane Departure Warning function is enabled, the lamp will extinguish when the function is disabled.
(This lamp will illuminate green when the Lane Departure Warning function is activated)
If the Lane Departure Warning System is not able to function normally the lamp will flash yellow and then remain on after a period of time.
|
Lane Departure Prevention System
|
This lamp will illuminate yellow when the Lane Departure Prevention function is enabled, the lamp will extinguish when the function is disabled
(This lamp illuminates green when the Lane Departure Prevention function is activated).
If the Lane Departure Prevention System is not able to function normally the lamp will flash yellow and then remain on after a period of time.
|
MG Pilot System Indicator
|
This lamp will illuminate yellow when the MG Pilot function is enabled, the lamp will extinguish when the function is disabled.
(This lamp illuminates green when the MG Pilot function is activated).
If the MG Pilot System is not able to function normally the lamp will flash yellow and then remain on after a period of time.
|
Forward Collision Warning System Indicator
|
This lamp will illuminate yellow when the Forward Collision Warning function is disabled.
If the Forward Collision System is not able to function normally the lamp will flash yellow and then remain on after a period of time.
|
Automatic Emergency Braking System (AEB) and Automatic Emergency Braking System for Pedestrians (AEBP) Indicator
|
This lamp will illuminate yellow when the Autonomous Emergency Braking System (AEB) or Autonomous Emergency Braking System for Pedestrian (AEBP) function is disabled.
If the AEB or AEBP system is not able to function normally the lamp will flash yellow and then remain on after a period of time.
|
Adaptive Cruise Control System Indicator
|
If the Adaptive Cruise function is enabled, the Adaptive Cruise Control System will enter the standby state, the lamp illuminates yellow.
(When the Adaptive Cruise Control System operates, the lamp will illuminate green, this indicates that the Adaptive
Cruise Control System is activated).
|
Adaptive Cruise Control System Malfunction
|
This lamp will illuminate if an Adaptive Cruise Control System failure is detected.
|
Manual Speed Assist System Indicator
|
This lamp will illuminate yellow when the Manual Speed Assist function is enabled, the lamp will extinguish when the function is disabled. If the current speed of the vehicle is above the maximum value allowed by the system the vehicle remains in the stand by state and the lamp will illuminate yellow.
(This lamp illuminates green when the Manual Speed Assist function is activated).
If the Manual Speed Assist System is not able to function normally the lamp will flash yellow and then extinguish. Please try to reinstate this function. If this function cannot be switched on, please contact an MG Authorised Repairer.
|
Intelligent Speed Assist System Indicator
|
This lamp will illuminate yellow when the Intelligent Speed Assist function is enabled, the lamp will extinguish when the function is disabled.
(This lamp illuminates green when the Intelligent Speed Assist function is activated).
If the Intelligent Speed Assist System is not able to function normally the lamp will flash yellow and then extinguish. Please try to reinstate this function. If this function cannot be switched on, please contact an MG Authorised Repairer
|
Speed Limit Sign Additional Information
Warning
|
This lamp will illuminate when the speed limit sign currently recognised has additional information. Please pay attention to it.
|
